Cisco D9800 - Page 6

The table below describes the symbols.
DescriptionLCD Symbol
Indicates that parameters are being saved in the background. You can
continue to perform any operation desired.
If a power-cycle/interruption occurs while the hourglass is
displayed, some parameters may not be saved. Refrain from
powering off the unit while the hourglass is displayed.
Note
Indicates that the INFO key is active. In most cases, this will display
contextual information on the LCD screen.
Indicates that the SELECT key is active.
The Download In Progress (DL) symbol indicates that the receiver is
currently downloading a software update and storing it into memory in the
background.
Service interruption occurs during a reboot, which is always
required during a software update.
Note
The Download Trigger (DT) symbol indicates that a new software is ready
for download, but a download trigger by the receiver is required before it
is downloaded.
Service interruption occurs during a reboot, which is always
required during a software update.
Note
The Download symbol indicates that a software download for a version of
software already in memory has been detected.
The Disaster Recovery (DR) symbol indicates that a disaster is declared on
the current receiver.
The NIT Retune (NR) symbol indicates that a NIT retune recovery is in
progress on the current receiver.
The Session Open symbol indicates that you are changing a group of related
items.
o
Cisco D9800 Network Transport Receiver Version 3.11 Installation and Configuration Guide
6
Getting Started
Startup Screen