Cisco D9800 Installing Manual

Connecting the Video Outputs
The video output connectors are of the BNC type. The interface type is SMPTE-292M and the connector type
is BNC female.
Connecting the Composite Video Output
Connect a video monitor to the CVBS connector. Use a 75-ohm double-braided coax cable.
Connecting the SDI Outputs
Connect rebroadcast equipment to the connectors labeled SDI1 and SDI2, and/or if required, connect them
to a video monitor.
Connecting the HDMI Output
Connect the video monitor to the HDMI connector. Use a HDMI Type A receptacle (female) connector.
Connecting the Audio Outputs
This section describes how to connect digital and balanced audio outputs.
Connecting the Digital Audio Outputs
The configuration of the D9800 receiver outputs two stereo channels. The receiver also supports encoding of
audio embedded in the SDI video signal.
The Interface type is AES-3id and the connector type is BNC female.
The digital audio output is always 75-ohm single-ended.Note
Connect digital audio output broadcast equipment to the AES-3id connectors. The two stereo channels are
useful for Dolby Digital 5.1 pass-through applications. Use a high-quality, double-shielded RG6 coaxial cable.
Cisco D9800 Network Transport Receiver Version 3.11 Installation and Configuration Guide
7
Installing the D9800 Network Transport Receiver
Connecting the Video Outputs

Cisco D9800 Specifications

General

Brand	Cisco
Model	D9800
Category	Receiver
Language	English