15
Cisco ENCS 5400-W Series Quick Start Guide
Configuring the ENCS 5400-W Device
Note We recommend that you disable the disk error-handling reload option if it is enabled
because it is not necessary to power down the system to remove a disk.
Step 4 After migration, verify that boot order is as shown in Figure 8.
Figure 8 Migration Equipment Configure Boot Order
CLI Commands Used with ENCS 5400-W
Table 6 shows the CLI commands used to display information about vWAAS on ENCS.
For an overview of CIMC CLI commands, see Initializing the ENCS 5400-W Device Remotely.
To Next Page
Loading...
