9
Cisco ENCS 5400-W Series Quick Start Guide
Powering Up and Initializing the ENCS 5400-W Device
Powering Up and Initializing the ENCS 5400-W Device
This section contains the following topics:
• About the ENCS 5400-W Front Panel
• Powering Up the ENCS 5400-W Device
• Initializing the ENCS 5400-W Device
About the ENCS 5400-W Front Panel
Figure 6 shows the ENCS 5400-W front panel and Table 5 describes each numbered component.
Figure 6 ENCS 5400-W Front Pane Detaill
Table 5 Components Shown in Figure 6, “ENCS-W Front Panel”
# Component Description
1
Power on/off switch • The power supply provides AC power.
–
The ENCS 5406-W supports only non-PoE (Power
over Ethernet) power, therefore the LAN ports of this
device cannot provide PoE.
–
The ENCS 5408-W and 5412-W support both PoE
and non-PoE power supply options.
–
If you want to upgrade from a non-PoE power supply
to a PoE power supply, you can do that by replacing
the power supply unit. The reverse is also possible
(replacing a PoE power supply with a non-POE power
supply).
–
The power supply can provide a total of 250 watts of
inline power across the 8 PoE capable ports in the
system; a maximum of 30 watts of PoE power per
port and 60 watts of UPoE power per port.
2
Integrated LAN ports • Optional PoE support is available for ENCS 5408-W and
5412-W.
To Next Page
Loading...
