occurring) between that port and another device on the network link. The
flashing frequency is proportional to the amount of traffic on the network link.
External connections
The switch-module external connections include
v Four external 1000BASE-T Ethernet connectors for connecting to external
Ethernet devices, such as backbones, end stations, and servers. These
connectors are identified as ports 17, 18, 19, and 20 in the switch
configuration menus and are labeled 17 through 20 (from top to bottom) on
the Gigabit Ethernet switch module.
v Serial port RS-232 connector for local console port connections.
12 Cisco Systems Intelligent Gigabit Ethernet Switch Module: Installation Guide
To Next Page
Need help?
General
