Cisco Ethernet switch User Manual

4. Define the SOL session on VLAN 3. At the console prompt, type:
config t
vlan 3
state active
exit
int gi0/15
sw trunk allow vlan add 3
int gi0/16
sw trunk allow vlan add 3
end
config t
int gi0/17
switchport trunk allowed vlan remove 3
int gi0/18
switchport trunk allowed vlan remove 3
int gi0/19
switchport trunk allowed vlan remove 3
int gi0/20
switchport trunk allowed vlan remove 3
end
5. To save the configuration, type write.
The
management module and the Gigabit Ethernet switch module are ready
for SOL traffic over the specified VLAN.
30 Cisco Systems Intelligent Gigabit Ethernet Switch Module: Installation Guide

Cisco Ethernet switch Specifications

General

Brand	Cisco
Model	Ethernet switch
Category	Network Router
Language	English

Summary

Introducing the Gigabit Ethernet Switch Module

Features and Specifications

Details the module's ports, performance, manageability, and security features.

Physical Components and Indicators

Describes major components, information panel, and LEDs for status monitoring.

External Connections

Details the external Ethernet and serial port connectors on the module.

Installing and Removing the Switch Module

Installation Guidelines and Safety

Provides essential steps and safety precautions before installing the switch module.

Handling Static-Sensitive Devices

Outlines precautions to prevent damage from electrostatic discharge during installation.

Installing a Gigabit Ethernet Switch Module

Step-by-step instructions for physically installing the switch module into the BladeCenter.

Removing a Gigabit Ethernet Switch Module

Step-by-step instructions for physically removing the switch module from the BladeCenter.

Configuring the Gigabit Ethernet Switch Module

Establishing Network Sessions

Guides on setting up TCP/IP, Telnet, Serial, and Web sessions for module management.

Enabling External Port Management

Steps to allow remote management access through the module's external Ethernet ports.

Initial VLAN Configuration

Steps for setting up the initial Virtual LAN (VLAN) configuration on the switch.

Configuring Serial Over LAN (SOL)

Configuring SOL on the Management Module

Steps to configure SOL settings on the BladeCenter management module.

Configuring SOL on the Gigabit Ethernet Switch Module

Steps to configure SOL settings on the switch module itself.

Updating Switch Module Software

Determining Current Software Level

How to check the installed Cisco IOS software version on the module.

Obtaining Latest Software

Instructions for finding and downloading the latest available software from IBM.

Upgrading Switch Module Software

Procedures for upgrading the switch module's operating system software via TFTP.

Resetting and Restarting the Module

Steps to reset and restart the module to activate software updates.

Getting Help and Technical Assistance

Before You Call for Support

Essential troubleshooting steps to perform before contacting IBM support.

Using Available Documentation

How to find and use the manual's documentation for technical assistance.

Online Support and Resources

Information on accessing IBM support via the web, software, and hardware services.

Troubleshooting and Problem Solving

Running Power-On Self-Test (POST)

Explains the POST process for checking module operational status during power-up.

Understanding POST Errors

Details critical and noncritical errors and how to interpret POST results.

IBM Limited Warranty Information

General Terms and Coverage

Outlines the general terms, what the warranty covers, and exclusions.

Country-Specific Warranty Terms

Details specific warranty terms and legal jurisdiction by country/region.

Warranty Service Types

Explains different types of warranty service provided by IBM (CRU, On-site, etc.).

Notices and Legal Information

Trademarks and Copyrights

Lists trademarks and copyright information for the product and IBM.

Product Recycling and Disposal

Information on responsible recycling and disposal of the product and batteries.

Electronic Emission Statements

Compliance statements for FCC, Industry Canada, EU EMC, and regional warnings.