Cisco Firepower 1010 Getting Started

Explicit, implied, or default
configurationConfigurationSetting
Implied.A data interface management access list rule allows HTTPS access
through the inside interface. SSH connections are not allowed.
Both IPv4 and IPv6 connections are allowed.
Firepower 4100/9300: No data interfaces have default
management access rules.
ISA 3000: No data interfaces have default management access
rules.
FTDv: No data interfaces have default management access rules.
Management access through
data interfaces.
Explicit.The time zone and NTP servers you selected.
Firepower 4100/9300: System time is inherited from the chassis.
ISA 3000: Cisco NTP servers: 0.sourcefire.pool.ntp.org,
1.sourcefire.pool.ntp.org, 2.sourcefire.pool.ntp.org.
System time.
Explicit.Either registered with a base license, or the evaluation period
activated, whichever you selected.
Subscription licenses are not enabled. Go to the smart licensing
page to enable them.
Smart license.
Default.192.168.95.1/24
Firepower 4100/9300: Data interfaces are not pre-configured.
ISA 3000: None. You must set the BVI1 IP address manually.
FTDv: 192.168.45.1/24
Inside interface IP address.
Default.Running on the inside interface with the address pool 192.168.95.5
- 192.168.95.254.
Firepower 4100/9300: No DHCP server enabled.
ISA 3000: No DHCP server enabled.
FTDv: The address pool on the inside interface is 192.168.45.46
- 192.168.45.254.
DHCP server for inside clients.
Explicit, but indirectly.Enabled on outside interface if you use DHCP to obtain the outside
interface IPv4 address.
If you use static addressing, DHCP auto-configuration is disabled.
DHCP auto-configuration for
inside clients.
(Auto-configuration supplies
clients with addresses for WINS
and DNS servers.)
Getting Started
30
Getting Started
Configuration After Initial Setup

Cisco Firepower 1010 Specifications

General

Brand	Cisco
Model	Firepower 1010
Category	Firewall
Language	English