Make sure you have the correct firmware package and software version installed to support this network
module. See Cisco FXOS Troubleshooting Guide for the Firepower 1000/2100 with Firepower Threat Defense
for the procedure to verify your firmware package and software version. See Cisco Firepower 2100 ASA
Platform Mode FXOS Configuration Guide for the procedure to upgrade the firmware package for the Firepower
2100 running ASA with FXOS. See the Cisco Firepower Compatibility Guide and the Cisco ASA Compatibility
guide, which provide Cisco software and hardware compatibility, including operating system and hosting
environment requirements, for each supported version
Note
The FPR2K-NM-8X10G is NEBS-compliant.
Note
You can fit four copper SFPs in either the top row of ports or the bottom row of ports. Both rows cannot be
populated at the same time, because of the port row spacing.
Note
Figure 15: FPR2K-NM-8X10G
Ethernet X/12Captive screw/handle1
Ethernet X/54Ethernet X/33
Ethernet X/26Ethernet X/75
Ethernet X/68Ethernet X/47
Network activity LEDs
• Off—No connection or port is not in use.
• Amber—No link or network failure.
• Green—Link up.
• Green, flashing—Network activity.
10Ethernet X/89
Cisco Firepower 2100 Series Hardware Installation Guide
20
Overview
10-Gb Network Module
To Next Page
Loading...
Need help?
General