Cisco Firepower 2100 Series Hardware Installation Guide

For More Information
• For a list of copper SFPs, see Supported SFP/SFP+ Transceivers, on page 31.
1-Gb Network Module
The following figure shows the front panel of the 1-Gb network module (FPR2K-NM-8X1G). The
FPR2K-NM-8X1G is a single-wide module that supports hot swapping. The eight ports are numbered from
top to bottom, left to right.
Make sure you have the correct firmware package and software version installed to support this network
module. See Cisco FXOS Troubleshooting Guide for the Firepower 1000/2100 with Firepower Threat Defense
for the procedure to verify your firmware package and software version. See Cisco Firepower 2100 ASA
Platform Mode FXOS Configuration Guide for the procedure to upgrade the firmware package for the Firepower
2100 running ASA with FXOS. See the Cisco Firepower Compatibility Guide and the Cisco ASA Compatibility
guide, which provide Cisco software and hardware compatibility, including operating system and hosting
environment requirements, for each supported version
Note
The FPR2K-NM-8X1G is NEBS-compliant.
Note
You can fit four copper SFPs in either the top row of ports or the bottom row of ports. Both rows cannot be
populated at the same time, because of the port row spacing.
Note
Figure 16: FPR2K-NM-8X1G
Ethernet X/12Captive screw/handle1
Ethernet X/54Ethernet X/33
Ethernet X/26Ethernet X/75
Cisco Firepower 2100 Series Hardware Installation Guide
21
Overview
1-Gb Network Module

Cisco Firepower 2100 Series Specifications

General

Brand	Cisco
Model	Firepower 2100 Series
Category	Firewall
Language	English