Cisco Firepower 2140 Hardware Installation Guide

Figure 34: Install the Cable Management Studs into the Rack-Mount Bracket
b) Install two 8-32-in. screws through the inside of the rack-mount bracket to secure the cable management bracket to
the rack-mount bracket.
Step 3 Attach the chassis with the installed rack-mount bracket to the rack using the screws that work for your rack.
What to do next
• Ground the Chassis, on page 54
• Connect Cables, Turn on Power, and Verify Connectivity for Cisco Firepower Threat Defense, on page
57
• Connect Cables, Turn on Power, and Verify Connectivity Using Cisco Firepower Management Center,
on page 60
• Connect Cables, Turn on Power, and Verify Connectivity for Cisco ASA, on page 62
Rack-Mount the Chassis Using Slide Rails
Take note of the following warnings:
Cisco Firepower 2100 Series Hardware Installation Guide
48
Mount and Connect
Rack-Mount the Chassis Using Slide Rails

Cisco Firepower 2140 Specifications

General

Model	Cisco Firepower 2140
Category	Firewall
Firewall Throughput	20 Gbps
Power Supply	Dual, Hot-swappable
Firewall Throughput (Maximum)	20 Gbps
Firewall Throughput (Application Visibility and Control AVC)	10 Gbps
Form Factor	1 RU
Memory	32 GB
Operating System	Cisco Firepower Threat Defense (FTD)
Maximum Concurrent Sessions	4, 000, 000
Network Interfaces	8 x 1G/10G SFP+
Concurrent Sessions	4, 000, 000
Interfaces	8 x 1G/10G SFP+
Throughput	20 Gbps