Table 1: FMC 1600, 2600, and 4600 Features
460026001600Feature
• Common Criteria (CC) on FTD 6.4.x
• Federal Information Processing Standards (FIPS) 140-2 on FTD 6.4.x
• Department of Defense Information Network Approved Product List (DoDIN
APL)
• US Government Compliance for IPv6 (USGv6) and Ready Logo certified
on FTD 6.4.x
See the "Security Certifications Compliance" topic in the "Appliance Platform
Settings" chapter in the Firepower Management Center Configuration Guide,
Version 6.7 for the instructions on how to enable security certifications
compliance.
Security standards
certifications
1 RUForm factor
Standard 19-in. (48.3 cm) 4-post EIA rackRack mount
Front to rear
Cold aisle to hot aisle
Airflow
Displays the serial number and the MAC address for the two built-in management
ports
Pullout asset card
Two threaded holes for a dual-hole grounding lug
Use is optional; the supported AC power supplies have internal grounding, so
no additional chassis grounding is required.
Grounding hole
On the front panelUnit identification button
On the rear panelPower button
Two Intel Xeon 4116
processors
Two Intel Xeon 4110
processors
One Intel Xeon 4110
processor
Processor
128-GB RAM64-GB RAM32-GB RAMMemory
Eight 16-GB
DDR4-2400-MHz
DIMMs
Four 16-GB
DDR4-2400-MHz
DIMMs
Two 16-GB
DDR4-2400-MHz
DIMMs
RDIMMs
Internal component only;
not field-replaceable
Two built-in RJ-45 SFP+ ports
Support for 1000 Mbps, 1 Gbps, and 10 Gbps
The primary management port is eth0. You can use eth1, eth2, and eth3 as
secondary management or event ports.
Management ports
Two USB 3.0 Type AUSB ports
Cisco Firepower Management Center 1600, 2600, and 4600 Hardware Installation Guide
2
Overview
Features
To Next Page
Loading...
Need help?
General
