Fiber Optic Cable Installation
12 Route each fiber to its intended module through the fiber track as shown.
13 Before connection, carefully clean the optical connectors on both fiber and
module according to the procedures in Care and Cleaning of Optical Connectors
(on page 134).
14 Open the receiver or transmitter module fiber connector cover. Carefully slide
the fiber connector into the module connector until it clicks.
15 Repeat steps 12 and 13 for each receiver and transmitter module.
16 Splice fiber pigtail of optical fiber input cable to your splice enclosure.
17 Continue to RF Cable Installation (on page 82).
To Next Page
Loading...
