Cisco IE 3000 - Installing SFP Modules and Connecting to Ports

23
Cisco IE 3000 Switch Getting Started Guide
OL-16234-01
Cisco IE 3000 Switch Getting Started Guide
Installing SFP Modules and Connecting to Ports
Follow these steps:
For a list of supported modules, see the release notes on Cisco.com. For detailed
instructions on installing, removing, and connecting to SFP modules, see the
documentation that came with the SFP module.
Caution Removing and installing an SFP module can shorten its useful life. Do not remove
and insert SFP modules more often than is absolutely necessary.
Step 1
Grasp the module on the sides, and insert it
into the switch slot until you feel the
connector snap into place.
Step 2
Insert an appropriate cable into the module
port.
Step 3
Insert the other cable end into the other device.
202326
202327