A-6
Cisco IE 4000 Switch Hardware Installation Guide
Appendix A Configuring the Switch with the CLI-Based Setup Program
Accessing the CLI Through the Console Port
Step 4 The Ready to Install the Program window appears, Click Install.
Note If a User Account Control warning appears, click Allow - I trust this program to proceed.
Step 5 The InstallShield Wizard Completed window appears. Click Finish.
Step 6 Connect the USB cable to the PC and the switch console port. The USB console port LED turns green,
and the Found New Hardware Wizard appears. Follow the instructions to complete the driver
installation.
To Next Page
Loading...
