Cisco IP 7940 - Page 11

Cisco IP Phone Configuration Guides
www.yeastar.com Page 11
Step4. Save the settings and reboot the IP phone. After you save the
changes, system will prompt you to save the changes and reboot to save
changes without rebooting. Click OK to reboot the IP phone and provisioning the
phone.
Figure 3-5
Note: The IP phone will reboot twice to apply the configuration take effect.
When done, you can see extension 500, 501, 503 have been registered on the
screen of Cisco IP phone.
Figure 3-6
Remark:
The factory default setting of DHCP for IP Phone is “enable”, so you can skip this
step.
If the DHCP is disabled, please follow below step to enable it.
1) Login IP phone’s web page.