Web Proxy Settings
These settings take effect if the Z3/Z3C device has to fall back to using HTTP to contact the Cloud Controller. By
default, web proxy is disabled. To enable web proxy, do the following:
• Choose Web proxy > Yes.
• Enter values as appropriate for Hostname or IP and Port.
• If you require authentication, choose Authentication > Use authentication, and enter appropriate values for
Username and Password.
To apply all configuration settings to the appliance, be sure to click Save Settings at the bottom of the page.
Configuring Physical Link Settings
To configure physical link settings on the Ethernet ports, click Local status > Ethernet configuration. You can enable
half duplex, full duplex, and autonegotiation, as well as set 10- or 100-Mbps data rates.
Basic Troubleshooting
The following steps can be used for troubleshooting basic connectivity issues with your Z3/Z3C.
• Reset the Z3/Z3C
• Factory reset the Z3/Z3C by holding the factory reset button for 5 seconds
• Try switching cables, or testing your cable on another device
Reference https://documentation.meraki.com/ for additional information and troubleshooting tips.
If you are still experiencing hardware issues, please contact Cisco Meraki support by logging in to dashboard and using
the Help option near the top of the page, then opening and email case or calling using the contact information on that
page.
Warranty
Z-series Warranty coverage periods are as follows:
Product
Warranty
Period
Warranty Information
Z-series (e.g.
Z3, Z3C)
Lifetime
Z-series
Accessories
1 Year
The following are considered accessories:
13
To Next Page
Loading...
