Cisco NCS 1001 - Configuring NCS 1001 Using Data Models; Supported YANG Models in NCS 1001

CHAPTER 3
Configuring NCS 1001 Using Data Models
This section includes examples for configuring NCS 1001 using Data models.
•
Supported YANG Models in NCS 1001, page 13
•
Configure Amplifier Module, page 14
•
Remove Amplifier Configuration, page 14
•
Configure Protection Switching Module, page 15
•
Remove Protection Switching Module Configuration, page 16
•
Configure OTS Controller, page 17
•
Display Parameters of OTS Controllers, page 23
•
Display Parameters of OTS OCH Controllers, page 24
•
View PM Parameters for OTS Controllers, page 25
Supported YANG Models in NCS 1001
The supported configuration and operational YANG models for NCS 1001 are listed below.
Oper. yangCfg. yang
Cisco-IOS-XR-controller-optics-oper.yangCisco-IOS-XR-ncs1001-ots-cfg.yang
Cisco-IOS-XR-pmengine-oper.yangCisco-IOS-XR-ifmgr-cfg.yang
Cisco-IOS-XR-plat-chas-invmgr-oper.yangCisco-IOS-XR-controller-optics-cfg.yang
Cisco-IOS-XR-alarmgr-server-oper.yangCisco-IOS-XR-pmengine-cfg.yang
Data Models Configuration Guide for Cisco NCS 1001
13