Cisco NCS 1001 - View PM Parameters for OTS Controllers

View PM Parameters for OTS Controllers
Use the Cisco-IOS-XR-pmengine-oper.yang YANG model to view the performance monitoring parameters for OTS
controllers.
ExampleParameter
<?xml version="1.0" ?>
<rpc message-id="8566" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<get>
<filter type="subtree">
<performance-management
xmlns="http://cisco.com/ns/yang/Cisco-IOS-XR-pmengine-oper">
<optics>
<optics-ports>
<optics-port>
<optics-current>
<optics-minute15>
<optics-minute15-optics>
<optics-minute15-optic>
<number>1</number>
</optics-minute15-optic>
</optics-minute15-optics>
</optics-minute15>
</optics-current>
<name>Ots0/2/0/0</name>
</optics-port>
</optics-ports>
</optics>
</performance-management>
</filter>
</get>
</rpc>
show controllers ots 0/2/0/0
pm current 15-min optics 1
Data Models Configuration Guide for Cisco NCS 1001
25
Configuring NCS 1001 Using Data Models
View PM Parameters for OTS Controllers