•
ESD wrist strap or other grounding device
•
Antistatic mat or antistatic foam
•
A Torx T15 screwdriver, or the Torx T15 key to install adapters.
•
Grounding cable (6 AWG recommended), sized according to local and national installation requirements;
the required length depends on the proximity of the switch to proper grounding facilities
•
Ground lug (1)
•
Crimping tool large enough to accommodate the girth of the lug
•
Wire-stripping tool
•
(ANSI) Pair of 19-inch mounting brackets
•
M4 screws to fix brackets (16)
•
M4 screws to fix ground lug (2)
Hardware Installation Guide for Cisco NCS 5500 Series Fixed-Port Routers
6
Prepare for Installation
Procure Tools and Equipment
To Next Page