Cisco Nexus 1000V - Page 4

Enabling or Disabling CDP 18
Clearing the Interface Counters 19
Verifying the Basic Interface Parameters 20
Feature History for Basic Interface Parameters 20
CHAPTER 4 Configuring Layer 2 Interfaces 23
Information About Access and Trunk Interfaces 23
Access and Trunk Interfaces 23
IEEE 802.1Q Encapsulation 24
High Availability 25
Prerequisites for VLAN Trunking 25
Guidelines and Limitations 25
Default Settings 26
Configuring Access and Trunk Interfaces 26
Configuring a LAN Interface as a Layer 2 Access Port 26
Configuring Trunk Ports 27
Configuring the Native VLAN for 802.1Q Trunking Ports 28
Configuring the Allowed VLANs for Trunking Ports 29
Tagging Native VLAN Traffic 30
Verifying the Interface Configuration 31
Monitoring the Interface Configuration 32
Configuration Examples for Access and Trunk Port Mode 32
Feature History for Layer 2 Interface Parameters 33
CHAPTER 5 Configuring Virtual Ethernet Interfaces 35
Information About vEthernet Interfaces 35
Guidelines and Limitations 36
Default Settings 36
Configuring vEthernet Interfaces 36
Configuring Global vEthernet Properties 36
Configuring a vEthernet Access Interface 38
Configuring a Private VLAN on a vEthernet Interface 39
Enabling or Disabling a vEthernet Interface 40
Verifying the vEthernet Interface Configuration 41
Monitoring the vEthernet Interface Configuration 43
Cisco Nexus 1000V for VMware vSphere Interface Configuration Guide, Release 5.x
iv
Contents