Cisco Nexus 1000V - Prerequisites to License Troubleshooting

--------------------------------------------------------------------------------
Port OutMcastPkts OutBcastPkts
--------------------------------------------------------------------------------
mgmt0 1001 1001
Eth8/2 11451 70
Veth1 108 1383772
control0 1001 0
Configuration Examples for vEthernet Interfaces
This example shows how to configure a vEthernet access interface and assign the access VLAN for that
interface:
switch# configure terminal
switch(config)# interface vethernet 100
switch(config-if)# switchport
switch(config-if)# switchport mode access
switch(config-if)# switchport access vlan 5
switch(config-if)#
This example shows how to configure a Layer 2 trunk interface, assign the native VLAN and the allowed
VLANs, and configure the device to tag the native VLAN traffic on the trunk interface:
switch# configure terminal
switch(config)# interface vethernet 1
switch(config-if)# switchport
switch(config-if)# switchport mode trunk
switch(config-if)# switchport trunk native vlan 10
switch(config-if)# switchport trunk allowed vlan 5, 10
switch(config-if)#
Feature History for vEthernet Interfaces
Feature InformationReleasesFeature Name
You can enable or disable the
following automatic vEthernet
interface controls:
•
Deleting unused vEthernet
interfaces
•
Purging of manual vEthernet
configurations
•
Creating vEthernet interfaces
4.2(1)SV1(4)Global vEthernet interface controls
This feature was introduced4.0(4)SV1(1)vEthernet interface parameters
Cisco Nexus 1000V for VMware vSphere Interface Configuration Guide, Release 5.x
44
Configuring Virtual Ethernet Interfaces
Configuration Examples for vEthernet Interfaces