Step 1 Attach the two cable management frames to the chassis as follows:
a) Position one of the cable management side frame assemblies on the vertical mounting bracket attached to one side
of the front of the chassis.
b) Secure the cable management frame with two M4 screws. (see the following figure).
•
Figure 6: Attaching a Cable Management Assembly to the Chassis
Two M4 screws to secure the cable management
frame to front mounting bracket on chassis.
3Cable management side frame1
Four M3 screws to secure top and bottom hood
frames to the chassis.
4Cable management bottom hood frame2
c) Repeat Steps 1a through 1b to attach the other cable management frame.
d) Place the top and bottom hood frame as shown in the figure. Secure the hood frames with four M3 screws.
Step 2 Attach the side filter to the cable management assembly as follows:
a) Remove 4 M3 screws as shown in the figure.
Installing the Switch Chassis
12
Installing the Switch Chassis
Installing Cable Management Frames onto the Chassis
To Next Page
Loading...
