Cisco Quad Camera - Quad Camera Factory Reset

Cisco Quad Camera, Precision 60, SpeakerTrack 60 and PTZ-12 Camera
D15296.10 Cisco Quad Camera, Precision 60, SpeakerTrack 60, and PTZ-12 Camera SEPTEMBER 2019.
Copyright © 2019 Cisco Systems, Inc. All rights reserved.
30
Camera guide
Quad Camera
A factory reset should only be performed by a system
administrator or in contact with Cisco technical support.
The camera will be reset to factory defaults, and all configu-
ration and logs will be erased.
It is not possible to undo a factory reset.
To perform a factory reset:
1. Locate the pinhole button at the back of the camera.
2. Use a pen or similar to press and hold the factory reset
button for about 6 seconds, until the white LED at the
front of the camera starts blinking.
3. The system restarts two times to complete the factory
reset operation. This procedure may take up to 5 minutes,
depending on the software version.
4. The white LED will start pulsing normally once the fac-
tory reset operation is complete and the unit is starting
normally.
Pinhole for
factory reset
Contents
Introduction
Physical interface
Connecting to a codec
Appendix
Factory reset
Factory reset