Cisco Quad Camera User Manual

Cisco Quad Camera, Precision 60, SpeakerTrack 60 and PTZ-12 Camera
D15296.10 Cisco Quad Camera, Precision 60, SpeakerTrack 60, and PTZ-12 Camera SEPTEMBER 2019.
Copyright © 2019 Cisco Systems, Inc. All rights reserved.
32
Camera guide
SpeakerTrack 60 Camera
Factory resetting the device
A factory reset should only be performed by a system
administrator or in contact with Cisco technical support.
The device will be reset to factory defaults, and all configu-
ration and logs will be erased.
If errors continue to occur, the cameras might have to be
reset too. See the next page for instructions on how to
reset the cameras.
It is not possible to undo a factory reset.
To perform a factory reset:
1. Unplug the power.
2. Remove the top cover of the SpeakerTrack 60 device.
3. Locate the pinhole button at the top of the SpeakerTrack
60.
4. Use a pen or similar to press and hold the factory reset
button for 5 seconds while plugging the power back in.
5. When the factory reset is complete, the device restarts
and the LED lights up.
1
REMOVE COVERREMOVE COVER
Pinhole for
factory reset
REMOVE COVERREMOVE COVER
2
3
Contents
Introduction
Physical interface
Connecting to a codec
Appendix
Factory reset
Factory reset

Cisco Quad Camera Specifications

General

Brand	Cisco
Model	Quad Camera
Category	Digital Camera
Language	English