Figure 9: Reversing the CMA
Metal button on outside of tab2CMA tab on end of width-adjustment slider1
Initial Server Setup
This section describes how to power on the server, assign an IP address, and connect to server management
when using the server in standalone mode.
Note
Server Default Settings
The server is shipped with these default settings:
• The NIC mode is Shared LOM EXT.
Shared LOM EXT mode enables the 1-Gb/10-Gb Ethernet ports and the ports on any installed Cisco
virtual interface card (VIC) to access the Cisco Integrated Management Interface (Cisco IMC).
• The NIC redundancy is Active-Active. All Ethernet ports are utilized simultaneously.
• DHCP is enabled.
• IPv4 is enabled.
Connection Methods
There are two methods for connecting to the system for initial setup:
Cisco Application Services Engine Hardware Installation Guide
16
Installing the Server
Initial Server Setup
To Next Page
Loading...
Need help?
General