CHAPTER 2
Installing the Server
• Preparing for Installation, on page 9
• Installing the Server in a Rack, on page 12
• Installing the Cable Management Arm (Optional), on page 14
• Reversing the Cable Management Arm (Optional), on page 15
• Initial Server Setup, on page 16
• Connecting to the Server Locally For Setup, on page 17
• Connecting to the Server Remotely For Setup, on page 18
• Updating the BIOS and Cisco IMC Firmware, on page 19
• Accessing the System BIOS, on page 19
• Smart Access Serial, on page 20
Preparing for Installation
This section contains the following topics:
Installation Warnings and Guidelines
Before you install, operate, or service a server, review the Regulatory Compliance and Safety Information for
important safety information.
Note
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work
on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard
practices for preventing accidents. Use the statement number provided at the end of each warning to locate
its translation in the translated safety warnings that accompanied this device.
Statement 1071
Warning
Cisco Application Services Engine Hardware Installation Guide
9
To Next Page
Loading...
Need help?
General