Need help?Do you have a question about the Cisco SE-CL-L3 and is the answer not in the manual?
Introduces the Cisco Application Services Engine as a platform for deploying Cisco Data Center applications.
Describes the external features of the server versions, including front panel components.
Shows the locations of field-replaceable components and service-related items within the server.
Provides a summary table of the server's key hardware features and specifications.
Outlines prerequisites and general information before installing the server.
Details important safety instructions and guidelines for server installation.
Specifies the necessary requirements for server rack installation, including dimensions.
Provides step-by-step instructions for physically mounting the server into a rack using slide rails.
Covers the initial power-on, IP address assignment, and management connection.
Details how to connect a keyboard and monitor directly for server setup.
Explains the procedure for setting up the server remotely via a management LAN.
Provides instructions for updating the server's BIOS and Cisco IMC firmware.
Provides information for interpreting front, rear, and internal LED states and buttons.
Details the status and meaning of the LEDs located on the server's front panel.
Explains the status and meaning of the LEDs located on the server's rear panel.
Describes the internal fault LEDs for CPUs, DIMMs, and fan modules.
Covers procedures for safely shutting down and removing power from the server.
Provides instructions on how to safely remove and replace the server's top cover.
Guides on hot-swapping SAS/SATA hard drives and SSDs.
Details the process for replacing NVMe SSDs in front-panel drive bays.
Details the process of replacing CPU processors and their heatsinks.
Provides steps for removing and installing memory DIMMs.
Details the procedure for replacing the server's power supply units.
Provides instructions for installing and replacing PCIe expansion cards.
Explains the purpose and use of service headers and jumpers for debugging.
Lists physical, environmental, and power specifications for the server.
Details the physical dimensions and weight of the server.
Outlines the operating and non-operating environmental requirements for the server.
Lists the power specifications for the supported power supply options.
Lists supported storage controllers (RAID/HBA) and their required cables.
Discusses firmware compatibility requirements for storage controllers.
Lists capabilities and best practices for mixing drive types in RAID groups.
Describes cabling connections for storage controllers and the backplane.
Introduces the embedded MegaRAID controller and its RAID capabilities.
Guides on enabling SATA modes for embedded RAID controllers via BIOS.
Provides steps to access the BIOS-integrated utility for software RAID configuration.
To Next Page
General