Security
Defining Management Access Method
385 Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3
20
STEP 1 Click Security > Mgmt Access Method > Profile Rules.
STEP 2 Select the Filter field, and an access profile. Click Go.
The selected access profile appears in the Profile Rule Table.
STEP 3 Click Add to add a rule.
STEP 4 Enter the parameters.
• Access Profile Name—Select an access profile.
• Rule Priority—Enter the rule priority. When the packet is matched to a rule,
user groups are either granted or denied access to the device. The rule
priority is essential to matching packets to rules, as packets are matched on
a first-fit basis.
• Management Method—Select the management method for which the rule
is defined. The options are:
- All—Assigns all management methods to the rule.
- Teln e t—Users requesting access to the device that meets the Telnet
access profile criteria are permitted or denied access.
- Secure Telnet (SSH)—Users requesting access to the device that meets
the Telnet access profile criteria, are permitted or denied access.
- HTTP—Assigns HTTP access to the rule. Users requesting access to the
device that meets the HTTP access profile criteria, are permitted or
denied.
- Secure HTTP (HTTPS)—Users requesting access to the device that
meets the HTTPS access profile criteria, are permitted or denied.
- SNMP—Users requesting access to the device that meets the SNMP
access profile criteria are permitted or denied.
• Action—Select Permit to permit the users that attempt to access the device
by using the configured access method from the interface and IP source
defined in this rule. Or select Deny to deny access.
• Applies to Interface—Select the interface attached to the rule. The options
are:
- All—Applies to all ports, VLANs, and LAGs.
- User Defined—Applies only to the port, VLAN, or LAG selected.
To Next Page
Loading...
Need help?
General
