Cisco SG300-10P - 1 Introduction; 2 Muxlab Ethernet Switch Setup Requirements

Cisco Ethernet Switch Quick Setup Guide
© MuxLab Inc. 2017 3
Introduction 1.
This document covers the basic setup requirements for a Cisco Ethernet Switch. The
setup examples and screen shots shown are for the Cisco model SG300-10P, but these
instructions are similar and applicable to other Cisco Ethernet Switch models.
MuxLab Ethernet Switch Setup Requirements 2.
All MuxLab AV over IP Transmitters and Receivers require IGMP support to be enabled
on the Ethernet Switch, and a select number of MuxLab units also require Jumbo
Frames to be enabled.
Also note that all models below work on a 1G Ethernet Switch, except for the 500760,
which requires a 10G Ethernet Switch.
The below table specifies the IGMP and Jumbo Frames requirement per MuxLab AV
over IP Transmitter / Receiver model.
AV over IP
Model
Ethernet Switch
BW Required
IGMP
Required
Jumbo Frame
Required
500752
1G
X
500753
1G
X
500754
1G
X
500755
1G
X
500755-AMP
1G
X
500756
1G
X
500757
1G
X
500758
1G
X
X
500759
1G
X
X
500760
10G
X
500762
1G
X
500770
1G
X
X
500771
1G
X
X