Cisco SG300-10PP User Manual

2 Cisco 300 Series Managed Switches
Welcome
Thank you for choosing the Cisco 300 Series Managed Switch, a Cisco
network communications device. This device is designed to be
operational right out of the box as a standard bridge. In the default
configuration, it will forward packets between connecting devices after
power up.
Before you begin installing the switch, make sure you have all of the
package contents available, access to the Cisco 300 Series Managed
Switch Administration Guide, and a PC with a web browser for using
web-based system management tools.
Package Contents
• Cisco 300 Series Managed Switch
• Rackmount Kit
• Wallmount Kit (only for the 8-port devices)
• Power Cord (power adapter included with 8-port devices)
• This Quick Start Guide
• Product CD
• Serial Cable
• Rubber Feet
This guide will familiarize you with the layout of the managed switch and
describe how to deploy the device in your network. For additional
information, see www.cisco.com/go/300switches.
Mounting the Cisco Switch
There are three ways to physically install the switch:
• Set the switch on a flat surface.
• Mount the switch on a wall (8-port devices only).
• Mount the switch in a standard rack (1 rack unit high).
1

Cisco SG300-10PP Specifications

General

Model	SG300-10PP
Ports	10
PoE Ports	8
PoE Budget	62W
Switching Capacity	20 Gbps
Forwarding Rate	14.88 Mpps
Layer	Layer 3
VLAN Support	Yes
Management	Web-based, CLI, SNMP
Power Supply	Internal
Standards Compliance	IEEE 802.3, 802.3u, 802.3ab, 802.3af, 802.3at
MAC Address Table Size	8K entries
Jumbo Frame Support	9KB
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90%