Name: Cisco SG350-28MP
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Security: IPv6 First Hop Security

Default Settings and Configuration

455 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4

STEP 4 Attach the policy to a VLAN, port or LAG using either the Policy Attachment (VLAN) or

Policy Attachment (Port) pages.

Neighbor Binding Work Flow

STEP 1 In the Neighbor Binding Settings page, enter the list of VLANs on which this feature is

enabled.

STEP 2 In this same page, set the global configuration values that are used if no values are set in a

policy.

STEP 3 If required, either configure a user-defined policy or add rules the default policies for the

feature.

STEP 4 Add any manual entries required in the Neighbor Binding Table page

STEP 5 Attach the policy to a VLAN, port or LAG using either the Policy Attachment (VLAN) or

Policy Attachment (Port) pages.

IPv6 Source Guard Work Flow

STEP 1 In the IPv6 Source Guard Settings page, enter the list of VLANs on which this feature is

enabled.

STEP 2 If required, either configure a user-defined policy or add rules to the default policies for the

feature.

STEP 3 Attach the policy to a VLAN, port or LAG using either the Policy Attachment (VLAN) or

Policy Attachment (Port) pages.

Default Settings and Configuration

If IPv6 First Hop Security is enabled on a VLAN, the switch traps the following messages by

default:

• Router Advertisement (RA) messages

Other manuals for Cisco SG350-28MP

Questions and Answers:

Need help?

Do you have a question about the Cisco SG350-28MP and is the answer not in the manual?

General