Cisco SG350-28MP User Manual

10 Cisco 350 Series Managed Switches
If this is the first time that you have logged on with the default
username and password, the following message appears:
Please change your password from the default
settings. Please change the password for better
protection of your network. Do you want to change
the password (Y/N) [Y]?
STEP 5 Enter Y, and set a new administrator password.
NOTE Password complexity is enabled by default. The password
must comply with the default complexity rules.
CAUTION Make sure that any configuration changes made are saved
before exiting.
You are now ready to configure the switch. Refer to www.cisco.com/go/
350switches to locate the CLI Guide for your switch.
NOTE If you are not using DHCP on your network, set the IP address type
on the switch to Static and change the static IP address and subnet mask
to match your network topology. Failure to do so may result in multiple
switches using the same factory default IP address of 192.168.1.254.

Cisco SG350-28MP Specifications

General

Model	SG350-28MP
Total System Ports	28
PoE Ports	24
Switching Capacity	56 Gbps
DRAM	512 MB
Flash Memory	256 MB
Form Factor	Rack-mountable
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1X, Port Security
Power Supply	Internal
MAC Address Table Size	16K entries
Jumbo Frame	9216 bytes
CPU	800 MHz
Layer	Layer 2/Layer 3
Layer 3 Features	Static routing, RIP
Management	Web GUI, CLI, SNMP
Dimensions	440 x 257 x 44 mm (17.3 x 10.1 x 1.73 in)
Operating Temperature	32°F to 113°F (0°C to 45°C)
Combo Ports (RJ45 + SFP)	2 combo ports
SFP Slots	2 SFP slots