EasyManua.ls Logo

Cisco SG500X-48P - Chapter 6: Administration: General Information; Device Models

Cisco SG500X-48P
548 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3 82
Administration: General Information
This section describes how to view system information and configure various
options on the device.
It covers the following topics:
Device Models
System Information
Console Settings (Autobaud Rate Support)
Rebooting the Device
Routing Resources
Monitoring Fan Status
Defining Idle Session Timeout
Pinging a Host
Traceroute
Device Models
All models can be fully managed through the web-based switch configuration
utility.
NOTE Each model can be set to Layer 3 system mode by using the System Mode and
Stack Management page, except for the SG500X/ESW2-550X models that always
run in both Layer 2 and Layer 3 system mode.
When the device operates in Layer 3 system mode, the VLAN Rate Limit, and QoS
policers are not operational. Other QoS Advanced mode features are operational.
Only the SG500X/ESW2-550X models support Virtual Router Redundancy
Protocol (VRRP), and Routing Information Protocol (RIP).

Table of Contents

Other manuals for Cisco SG500X-48P

Related product manuals