Port Management
Port Settings
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 163
10
• Administrative Port Speed—Select the speed of the port. The port type determines the
available speeds. You can designate Administrative Speed only when port auto-
negotiation
is disabled.
• Operational Port Speed—Displays the current port speed that is the result of
negotiation.
• Administrative Duplex Mode—(Only displayed on non-XG ports) Select the port
duplex mode. This field is configurable only when auto-negotiation is disabled, and the
port speed is set to 10M or 100M. At port speed of 1G, the mode is always full duplex.
The possible options are:
- Half—The interface supports transmission between the device and the client in only
one direction at a time.
- Full—The interface supports transmission between the device and the client in both
directions simultaneously.
• Operational Duplex Mode—(Only displayed on non-XG ports) Displays the ports
current duplex mode.
• Auto Advertisement—Select the capabilities advertised by auto-negotiation when it is
enabled.
NOTE Not all options are relevant for all devices.
The options are:
- Max Capability—All port speeds and duplex mode settings can be accepted.
- 10 Half—10 Mbps speed and Half Duplex mode (does not appear on XG devices)
- 10 Full—10 Mbps speed and Full Duplex mode (does not appear on XG devices)
- 100 Half—100 Mbps speed and Half Duplex mode (does not appear on XG devices)
- 100 Full—100 Mbps speed and Full Duplex mode.
- 1000 Full—1000 Mbps speed and Full Duplex mode.
- 2500 Full—The LAG advertises a 2500 Mbps speed and the mode is full duplex.
This is only supported on the 550 family.
- 5000 Full—The LAG advertises a 5000 Mbps speed and the mode is full duplex.
This is only supported on the 550 family.
- 10000 Full—The LAG advertises a 10000 Mbps speed and the mode is full duplex.
This is only supported on the 550 family.
To Next Page
Loading...
Need help?
General
