Getting Started
Starting the Web-based Configuration Utility
1
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x 9
Launching the Configuration Utility
To open the web-based configuration utility:
STEP 1 Open a Web browser.
STEP 2 Enter the IP address of the device you are configuring in the address bar on the browser, and
then press Enter.
NOTE When the device is using the factory default IP address of 192.168.1.254, its system LED
flashes continuously. When the device is using a DHCP-assigned IP address or an
administrator-configured static IP address, the system LED is on solid.
On the SG350XG and the SG550XG, the default IP address 192.168.1.254 is configured to the
OOB port of the device, while on the other devices it is configured on the default VLAN (Vlan
1). To access the device with the IP address configured on the OOB port, make sure the OOB
port is connected to your network or PC.
Logging In
The default username/password is cisco/cisco. The first time that you log in with the default
username and password, you are required to enter a new password.
NOTE If you have not previously selected a language for the GUI, the language of the Login page is
determined by the language(s) requested by your browser and the languages configured on your
device. If your browser requests Chinese, for example, and Chinese has been loaded into your
device, the Login page is automatically displayed in Chinese. If Chinese has not been loaded
into your device, the Login page appears in English.
The languages loaded into the device have a language and country code (en-US, en-GB and so
on). For the Login page to be automatically displayed in a particular language, based on the
browser request, both the language and country code of the browser request must match those
of the language loaded on the device. If the browser request contains only the language code
without a country code (for example: fr). The first embedded language with a matching
language code is taken (without matching the country code, for example: fr_CA).