Administration
Routing Resources
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x 72
5
To reboot the device:
STEP 1 Click Administration > Reboot.
STEP 2 Click the Reboot button to reboot the device.
• Reboot—Reboots the device. Since any unsaved information in the Running
Configuration is discarded when the device is rebooted, you must click Save in the
upper-right corner of any window to preserve current configuration across the boot
process. If the Save option is not displayed, the Running Configuration matches the
Startup Configuration and no action is necessary.
The following options are available:
- Immediate—Reboot immediately.
- Date—Enter the date (month/day) and time (hour and minutes) of the schedule
reboot. This schedules a reload of the software to take place at the specified time
(using a 24-hour clock). If you specify the month and day, the reload is scheduled
to take place at the specified time and date. If you do not specify the month and day,
the reload takes place at the specified time on the current day (if the specified time
is later than the current time) or on the next day (if the specified time is earlier than
the current time). Specifying 00:00 schedules the reload for midnight. The reload
must take place within 24 days.
NOTE This option can only be used if the system time has either been set manually or
by SNTP.
- In—Reboot within the specified number of hours and minutes. The maximum
amount of time that can pass is 24 days.
• Restore to Factory Defaults—Reboots the device by using the factory default
configuration. This process erases all except the Active Image, Inactive Image, Mirror
configuration and Localization files
The stack unit ID is set to auto.
• Clear Startup Configuration File—Check to clear the startup configuration on the
device for the next time it boots up.
Routing Resources
TCAM entries are divided into the following groups:
To Next Page
Loading...
