Cisco SG550XG-24T User Manual

IP Configuration
IPv4 Management and Interfaces
263 Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
15
• Metric—Cost of this hop (a lower value is preferred).
• Administrative Distance—The administrative distance to the next hop (a lower value
is preferred). This is not relevant for static routes.
• Outgoing Interface—Outgoing interface for this route.
STEP 2 Click Add.
STEP 3 Enter values for the following fields:
• Destination IP Prefix—Enter the destination IP address prefix.
• Mask—Select and enter information for one of the following:
- Network Mask—IP route prefix for the destination IP.
- Prefix Length—IP route prefix for the destination IP.
• Route Type—Select the route type.
- Reject—Rejects the route and stops routing to the destination network via all
gateways. This ensures that if a frame arrives with the destination IP of this route, it
is dropped.
- Remote—Indicates that the route is a remote path.
• Next Hop Router IP Address—Enter the next hop IP address or IP alias on the route.
NOTE You cannot configure a static route through a directly-connected IP subnet where
the device gets its IP address from a DHCP server.
• Metric—Enter the administrative distance to the next hop. The range is 1–255.
STEP 4 Click Apply. The IP Static route is saved to the Running Configuration file.
RIPv2
See IP Configuration: RIPv2.
VRRP
See IP Configuration: VRRP

Cisco SG550XG-24T Specifications

General

Brand	Cisco
Model	SG550XG-24T
Category	Switch
Language	English