IP Configuration
IPv4 Management and Interfaces
277 Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
15
STEP 1 Click IP Configuration > IPv4 Management and Interfaces > DHCP Snooping/Relay >
DHCP Snooping Binding Database.
To see a subset of entries in the DHCP Snooping Binding database, enter the relevant search
criteria in the filter and click Go.
The fields in the DHCP Snooping Binding Database are displayed. These are described in the
Add page, except for the IP Source Guard field:
• Status—
- Active—IP Source Guard is active on the device.
- Inactive—IP Source Guard is not active on the device.
• Reason—
- No Problem
- No Resource
- No Snoop VLAN
- Trust Port
STEP 2 To add an entry, click Add.
STEP 3 Enter the fields:
• VLAN ID—VLAN on which packet is expected.
• MAC Address—MAC address of packet.
• IP Address—IP address of packet.
• Interface—Unit/Slot/Interface on which packet is expected.
• Type—The possible field values are:
- Dynamic—Entry has limited lease time.
- Static—Entry was statically configured.
• Lease Time—If the entry is dynamic, enter the amount of time that the entry is to be
active in the DHCP Database. If there is no Lease Time, check Infinite.)
STEP 4 Click Apply. The settings are defined, and the device is updated.
To Next Page
Loading...
Need help?
General
