IP Configuration
IPv6 Management and Interfaces
307 Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
15
• Interface—Interface used to forward the packet.
• Next Hop—Type of address to which the packet is forwarded. Typically, this is the
address of a neighboring router. It can be one of the following types.
- Link Local—An IPv6 interface and IPv6 address that uniquely identifies hosts on a
single network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link local
address is supported. If a link local address exists on the interface, this entry
replaces the address in the configuration.
- Global—An IPv6 address that is a global Unicast IPV6 type that is visible and
reachable from other networks.
- Point-to-Point—A Point-to-point tunnel.
• Metric—Value used for comparing this route to other routes with the same destination
in the IPv6 router table. All default routes have the same value.
• Lifetime—Time period during which the packet can be sent, and resent, before being
deleted.
• Route Type—How the destination is attached, and the method used to obtain the entry.
The following values are:
- S (Static) —Entry was manually configured by a user.
- I (ICMP Redirect)—Entry is an ICMP redirect dynamic route received from an
IPv6 router by using ICMP redirect messages.
- ND (Router Advertisement)—Entry is taken from a router advertisement message.
STEP 4 To add a new route, click Add and enter the fields described above. In addition, enter the
following field:
• IPv6 Address—Add the IPv6 address of the new route.
STEP 5 Click Apply to save the changes.
DHCPv6 Relay
This section covers the following topics:
• Global Destinations
• Interface Settings
To Next Page
Loading...
Need help?
General
