Cisco SG550XG-24T

To Next Page

To Previous Page

Security: IPv6 First Hop Security

Common Tasks

551 Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x

STEP 4 Attach the policy to a VLAN, port or LAG using either the Policy Attachment (VLAN) or

Policy Attachment (Port) pages.

Router Advertisement Guard Work Flow

STEP 1 In the RA Guard Settings page, enter the list of VLANs on which this feature is enabled.

STEP 2 In this same page, set the global configuration values that are used if no values are set in a

policy.

STEP 3 If required, either configure a user-defined policy or add rules to the default policies for the

feature.

STEP 4 Attach the policy to a VLAN, port or LAG using either the Policy Attachment (VLAN) or

Policy Attachment (Port) pages.

DHCPv6 Guard Work Flow

STEP 1 In the DHCPv6 Guard Settings page, enter the list of VLANs on which this feature is enabled.

STEP 2 In this same page, set the global configuration values that are used if no values are set in a

policy.

STEP 3 If required, either configure a user-defined policy or add rules to the default policies for the

feature.

STEP 4 Attach the policy to a VLAN, port or LAG using either the Policy Attachment (VLAN) or

Policy Attachment (Port) pages.

Neighbor Discovery Inspection Work Flow

STEP 1 In the ND Inspection Settings page, enter the list of VLANs on which this feature is enabled.

STEP 2 In this same page, set the global configuration values that are used if no values are set in a

policy.

STEP 3 If required, either configure a user-defined policy or add rules to the default policies for the

feature.

Cisco SG550XG-24T - Page 567