Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide 7
To configure the access point by using CCA:
STEP 1 Connect the Ethernet port on the access point to a switch port on a
SBCS device and power on the Cisco AP541N.
STEP 2 Connect a PC with CCA installed to any access switch port on the
UC520 or SR520.
STEP 3 Create a new CCA site by entering a name and the IP address of
the UC520 or SR520.
STEP 4 Connect to the CCA site by using the appropriate login credentials.
STEP 5 Click Window > Topology View.
When you have connected to the CCA site and the devices have
been discovered, the Topology map includes the Cisco AP541N.
NOTE Any non-SBCS devices connected to the switch are not shown
in the Topology map.
STEP 6 Right-click the access point to display the options: Configuration
Utility, Properties, and Annotation.
STEP 7 Click Configuration Utility.
The Access Point Configuration Utility
displays in a new window.
To Next Page
Loading...
