Cisco SNS 3515 User Manual

The console displays a set of parameters. You must enter the parameters as described in the following table
Table 1: Cisco ISE Setup Program Parameters
ExampleDescriptionPrompt
isebeta1Must not exceed 15 characters. Valid characters include
alphanumerical (A–Z, a–z, 0–9), and the hyphen (-). The first
character must be a letter.
We recommend that you use lowercase letters to ensure
that certificate authentication in Cisco ISE is not impacted
by minor differences in certificate-driven verifications.
You cannot use "localhost" as hostname for a node.
Note
Hostname
10.12.13.14Must be a valid IPv4 address for the Gigabit Ethernet 0 (eth0)
interface.
(eth0) Ethernet
interface address
255.255.255.0Must be a valid IPv4 netmask.Netmask
10.12.13.1Must be a valid IPv4 address for the default gateway.Default gateway
example.comCannot be an IP address. Valid characters include ASCII
characters, any numerals, the hyphen (-), and the period (.).
DNS domain
name
10.15.20.25Must be a valid IPv4 address for the primary name server.Primary name
server
(Optional) Allows you to
configure multiple name
servers. To do so, enter y to
continue.
Must be a valid IPv4 address for an additional name server.Add/Edit another
name server
clock.nist.govMust be a valid IPv4 address or hostname of a Network Time
Protocol (NTP) server.
Primary NTP
server
(Optional) Allows you to
configure multiple NTP
servers. To do so, enter y to
continue.
Must be a valid NTP domain.Add/Edit another
NTP server
Cisco Identity Services Engine Hardware Installation Guide, Release 2.0.1
36
Install Cisco ISE Software on the SNS 3515 and SNS 3595 Appliances
Install the ISE Server

Cisco SNS 3515 Specifications

General

Brand	Cisco
Model	SNS 3515
Category	Server
Language	English