EasyManuals Logo

Cisco SNS 3515 User Manual

Cisco SNS 3515
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
StateLED Name
OffNo link is present.
GreenLink is active.
Green, blinkingTraffic is present on the active
link.
1-GbE Ethernet link status
OffThe unit identification LED is not in use.
BlueThe unit identification LED is activated.
Rear unit identification
AC power supplies:
OffNo AC input (12 V main power off, 12 V
standby power off).
Green, blinking12 V main power off; 12 V
standby power on.
Green, solid12 V main power on; 12 V
standby power on.
Amber, blinkingWarning detected but 12 V
main power on.
Amber, solidCritical error detected; 12 V
main power off.
Power supply status
Internal Diagnostic LEDs
The server has internal fault LEDs for CPUs, DIMMs, fan modules, SD cards, the RTC battery, and the mLOM
card. These LEDs are available only when the server is in standby power mode. An LED lights amber to
indicate a faulty component.
Power must be connected to the server for these LEDs to be operate.Note
Cisco Identity Services Engine Hardware Installation Guide, Release 2.0.1
8
Install Cisco ISE Software on the SNS 3515 and SNS 3595 Appliances
Cisco SNS 3500 Series Appliances

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SNS 3515 and is the answer not in the manual?

Cisco SNS 3515 Specifications

General IconGeneral
BrandCisco
ModelSNS 3515
CategoryServer
LanguageEnglish

Related product manuals