Cisco SPA112 Administration Guide

Configuring the Voice Settings
Line1 and Line 2 Settings (PHONE Port1 and PHONE2)
Cisco SPA100Series Administration Guide 93
4
Field Description
Call Waiting Serv Enable Call Waiting Service.
Default setting: yes
Block CID Serv Enable Block Caller ID Service.
Default setting: yes
Block ANC Serv Enable Block Anonymous Calls Service
Default setting: yes
Dist Ring Serv Enable Distinctive Ringing Service
Default setting: yes
Cfwd All Serv Enable Call Forward All Service
Default setting: yes
Cfwd Busy Serv Enable Call Forward Busy Service
Default setting: yes
Cfwd No Ans Serv Enable Call Forward No Answer Service
Default setting: yes
Cfwd Sel Serv Enable Call Forward Selective Service. Configure this
service in the Selective Call Forward Settings section.
Default setting: yes
Cfwd Last Serv Enable Forward Last Call Service
Default setting: yes
Block Last Serv Enable Block Last Call Service
Default setting: yes
Accept Last Serv Enable Accept Last Call Service
Default setting: yes
DND Serv Enable Do Not Disturb Service
Default setting: yes
CID–Serv Enable Caller ID Service
Default setting: yes
CWCID Serv Enable Call Waiting Caller ID Service
Default setting: yes
Call Return Serv Enable Call Return Service
Default setting: yes

Cisco SPA112 Specifications

General

Supported network protocols	IPv4, IPv6, ARP, DNS, SRV, DHCP, PPPoE, ICMP, TCP, UDP, RTP, RTCP, SNTP
DHCP client	Yes
VPN support	802.1p
Security algorithms	SSL/TLS
Authentication method	SIP
Modem (RJ-11) ports	2
Ethernet LAN (RJ-45) ports	1
Voice codecs	G.711, G.726, G.729
Certification	FCC, CE, ICES, A-Tick, RoHS, UL
Fax compatibility	T.38
Output current	2 A
Output voltage	5 V
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Storage temperature (T-T)	-25 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Width	101 mm
Height	28 mm
Weight	153 g