Voice Parameters
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 144
6
<DECT_Enable> To enable this handset for service, select yes. Otherwise,
select no.
Default setting: yes
<Call_Park_Enable> Enables or disables Call Park.
Default setting: No
<Call_Pickup_Enable> Enables or disables Call Pickup.
Default setting: No
<Call_Group_Pickup_Enable> Enables or disables Group Pickup.
Default setting: No
<Outgoing_Lines> A comma-separated list of the index numbers (1~10) for the
lines that are available from this handset for an outgoing call.
These lines will be listed on the phone screen when the user
displays the call options or holds down the green call button.
Example: 1,2,8
In this example, a user can select DECT line 1, 2, or 8 for an
outbound call.
Default setting: 1
Note: You also can choose these lines from the DECT
Handset Outgoing Line Selection section of the Quick Setup
page.
<Failover> When this feature is enabled and a call fails through the
selected line, the ATA automatically attempts to place the call
over another enabled DECT line. Select yes to enable this
feature or select no to disable it.
Default setting: no
<Deregister> To deregister a handset, select yes. After you submit the
settings and the voice module reboots, then the handset is
deregistered. At that point, this parameter is reset to the
default value.
Default setting: no
To Next Page
Loading...
Need help?
General
