Cisco TelePresence MX800 Single - Step 2: Remove Loudspeaker

D15298.01 MX800 Single Replacement Guide, MARCH 2015. www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
12
Cisco TelePresence MX800 Single Replacement Guide
Replace a loudspeaker (page 2 of 2)
Step 2: Remove loudspeaker
Pull loudspeaker 10-15 cm (4-6 inch) out. Unplug the cable from the connector on
the back of the loudspeaker.
The same procedure applies for
loudspeakers in all positions.
When reconnecting the loudspeakers,
make sure to connect the correct cable.
Re-assembly:
In order to install the new loudspeaker, follow all the steps in reversed order.
Remove screw.
PT4x10, Torx T20
2a 2b 2c