Cisco TelePresence MX800 Single - Step 2: Remove Loudspeaker

D15298.01 MX800 Single Replacement Guide, MARCH 2015. www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
20
Cisco TelePresence MX800 Single Replacement Guide
Replace the dual camera module (page 2 of 7)
Step 2: Remove loudspeakers from positions 2, 3, 5 and 6
The illustrations below show the loudspeaker in position 3
for the single camera version. Perform these steps for the
loudspeakers in positions 2, 3, 5 and 6 for the dual camera
version.
When reconnecting the loudspeakers, make sure to
connect the correct cable. The cables are marked with the
loudspeaker’s position (see illustration). Note that position 4
is not in use.
Loudspeaker
positions
Pull loudspeaker 10-15 cm (4-6 inch) out. Unplug the cable from the connector
on the back of the loudspeaker.
Remove screw.
PT4x10, Torx T20
3
6
5
2
2a 2b 2c