D15298.01 MX800 Single Replacement Guide, MARCH 2015. www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
32
Cisco TelePresence MX800 Single Replacement Guide
Replace the PoE injector (page 2 of 2)
Step 2: Remove the PoE injector
Disconnect cables:
1 × Power (top)
2 × RJ45 for Ethernet
and Touch 10 user
interface (bottom).
Remove screws and
washers.
Remove PoE injector.
2 × M3x8 (pan),
Torx T10
Re-assembly:
In order to install the new PoE injector, follow all the steps in reverse order.
2a 2b 2c
To Next Page
Loading...
