D14949.13 SX20 Codec API Reference Guide TC7.3, OCTOBER 2015. Copyright © 2015 Cisco Systems, Inc. All rights reserved. 117
Cisco TelePresence SX20 Codec API Reference Guide
xCommand Provisioning CUCM ExtensionMobility Login
Login command for the Extension Mobility service. You login to the Extension Mobility service with a
user name and pin. If there are multiple profiles available for that user, a separate event will be sent
with the available profiles for the user. A new login command with the profile can then be submitted.
Requires user role: USER
Parameters:
UserId(r): <S: 1, 255>
Pin(r): <S: 1, 255>
Profile: <S: 1, 255>
Example:
xCommand Provisoning CUCM ExtensionMobility Login UserId: user1 Pin: 1234
xCommand Provisioning CUCM ExtensionMobility Logout
This command will log you out of your Extension Mobility profile.
Requires user role: USER
Example:
xCommand Provisioning CUCM ExtensionMobility Logout
xCommand Provisioning CUCM ITL Show
Shows the content of the installed Identity Trust List file (ITL), if it exists. Each entry displayed
contains the information about one specific certificate. If a certificate has been deleted in CTL, it is
marked accordingly in the output.
Requires user role: USER
Example:
xCommand Provisioning CUCM ITL Show
xCommand Provisioning CompleteUpgrade
Starts installing the software upgrade if you wish to install it before it is set to do so.
Requires user role: USER
Example:
xCommand Provisioning CompleteUpgrade
xCommand Provisioning PostponeUpgrade
Postpones the installing of the software upgrade.
Requires user role: USER
Parameters:
SecondsToPostpone(r): <0..65534>
Example:
xCommand Provisioning PostponeUpgrade SecondsToPostpone: 60
xCommand Provisioning StartUpgrade
The codec software can be upgraded from the provisioning server. When starting the upgrade the
software is automatically downloaded and installed. The codec reboots to complete the software
upgrade.
Requires user role: ADMIN
Example:
xCommand Provisioning StartUpgrade
To Next Page
Loading...
Need help?
General
