Cisco TelePresence SX20 Codec User Manual

D14949.13 SX20 Codec API Reference Guide TC7.3, OCTOBER 2015. Copyright © 2015 Cisco Systems, Inc. All rights reserved. 97
Cisco TelePresence SX20 Codec API Reference Guide
CamCtrlPip commands
xCommand CamCtrlPip
Show or hide the camera self-view in a small window (picture in picture).
Mode: Select whether the self-view picture in picture is on or off.
Duration: Set how long the self-view is shown for on screen.
Requires user role: USER
Parameters:
Mode(r): <On/Off>
Duration: <0..60>
Example:
xCommand CamCtrlPip Mode: On Duration: 30
Camera commands
xCommand Camera PanTiltReset
The camera is reset to its default values for pan and tilt. If the camera is daisy chained, the
CameraId is given by its place in the chain.
Requires user role: USER
Parameters:
CameraId(r): <1..1>
Example:
xCommand Camera PanTiltReset CameraId:1
xCommand Camera PositionActivateFromPreset
Selects pan, tilt, zoom and focus parameters for the given camera id from the selected preset.
CameraId: Give the camera id.
PresetId: Select preset 1 to 15.
Requires user role: USER
Parameters:
CameraId(r): <1..1>
PresetId(r): <1..15>
Example:
xCommand Camera PositionActivateFromPreset CameraId:1 PresetId:1
xCommand Camera PositionReset
Reset the camera position the the default position.
Requires user role: USER
Parameters:
CameraId(r): <1..1>
Example:
xCommand Camera PositionReset CameraId:1
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xCommand

Cisco TelePresence SX20 Codec Specifications

General

Brand	Cisco
Model	TelePresence SX20 Codec
Category	Conference System
Language	English